Home arrow Crack Injection

Crack Injection Products 

KÖSTER AQUATECNIC supply a wide range of crack injection products. The KÖSTER range is of the highest quality and offers an unrivalled choice of injection resins, foams and gels to suit every possible application.

 

 KB PUR IN 1 Crack Injection

  KÖSTER KB Pur® IN 1 Injection Foam

Water activated hydrophobic MDI based polyurethane isocyanate foam. the system only reacts if it has contact with water. It then expands to a stiff, waterproof polyurethane foam. volume extension x30. free of solvents and fillers, resistant to hydrolysis.

KB PUR N 2 Injection resin

KÖSTER KB-Pur® IN 2 Injection Resin

Solvent-free, low viscous, 2-component polyurethane injection resin. It is permanently elastic and designed to withstand continuous contraction and expansion and is thus ideal for repair of moving cracks. viscosity appr. 200mPa.s

KÖSTER KB-Pur® 2 IN 1 Injection Resin

Water activated, solvent-free, polyurethane injection resin. Suitable as injection foam at water bearing cracks and joints as well as flexible solid-resin for permanent crack sealing.


KÖSTER KB-Pur® IN 3 Injection Resin

Solvent-free, rigid, low viscous, 2-component polyurethane injection resin. compressive strength>80N/mm², tensile strength 14N/mm²,. for compression-resistant and tension-proof injection of cracks and joints.

KÖSTER KB-Pur® IN 4 Injection Resin

Solvent-free, elastic, low viscous, 2-component polyurethane resin. Pot life up to 6 hours. For use with injection hoses.

KÖSTER KB-Pur®IN 5 Injection Resin

2-component, low viscous, elastic polyurethane injection resin. Viscosity (25°C) appr. 70mPa.s. For sealing of fine cracks and for injection by use of injection hoses.

KÖSTER KB Pur® IN 7 Injection Foam

2-component, water activated, flexible injection foam. volume extension x30. For one-step sealing of water bearing cracks. 

KÖSTER KB Pur® Casting Foam 10

2-component, highly pressure resistant, expanding polyurethane jointing material for casting into voids and hollows. Volume extension up to x10. 

KÖSTER 2-C-Pur® Foam

Fast curing 2-component polyurethane foam with high mechanical firmness for quick filling of voids. 

 

Crack injection equipment

KÖSTER Crack Injection Equipment

To complement our range of injection materials, AQUATECNIC also supply an unrivalled range of injection equipment this includes:-

Injection Ports
Impact Packers
Hand Pumps
Injection Lances
Distribution Lances
1C and 2C Electric Pump Units
Special KÖSTER system for direct injection of cracks in floor slabs.


For further information, or to order any of these products please contact us on 0845 226 8283.










Built by Cawkwell ITS Printable version